Setup WIN3.1 907/PCI Vector driver with TechJET Designer Parallel Port:
Technical Support Hot Line (800) 225-2667               Updated: 7 Oct., 1997
                                                       
The Windows CCRF/PS/907/PCI driver file (WIN31DRV.EXE), 
may be downloaded from the CalComp Website (http://www.calcomp.com) 
Self-extract the file by typing at the DOS prompt: WIN31DRV

Hardware Connection Requirements:
  PC Host Computer with a working parallel port (i.e. lpt1).
  Parallel cable, Centronics connector.
  CalComp 54xx Plotter must be connected to a PC directly for this
  configuration.  Network systems may require different communication
  parameter settings.

1. Setup Designer (5424, 5436, 5424R, 5436R):
   - Power ON the plotter. Load media. Make sure both pinch rollers are down.
     Press MENU button.
   - Press DOWN arrow key to PROTOCOL and set to PCI.
   - Press DOWN arrow key to INPUT RESOLUTION and set to 360 DPI.
   - Press DOWN arrow key to PORT TYPE and set to CENTRONICS.
   - Press DOWN arrow key to EOP TIMER and set to Disabled.
   - Press DOWN arrow key to INPUT BUFFER and set to 100K.
   - Press DOWN arrow key to STITCH FACTOR and set to 0.
   - Press DOWN arrow key to Save as user number and save the settings
     on USER # (1 to 4).
   - Press ONLINE button twice.
   - The plotter should say "ONLINE    000:00".

2. Setup Windows Driver:
   	o	Start up windows.
  	o	Double click on Control Panel.
  	o	Double click on Printers.
   	o	Highlight the appropriate CCP TechJet Designer 
		54xx driver. (If the Windows Vector driver is not 
		installed, install it now by selecting RUN from the 
		File menu bar in Program Manager and selecting
     		the SETUP.EXE file from the disk directory where 
		the Windows driver is located.  Then follow the menu 
		choices, selecting the appropriate TechJET Designer 
		54xx 907/PCI Vector-mode plotter driver. When done, 
		double click on Control Panel, double click on Printers, 
		and select the driver).
   	o	Choose connect and select the LPT port that the 
		plotter is connected to.
   	o	Choose OK.
   	o	Select Fast Printing Direct to Port.
   	o	Choose OK
   	o	Choose Setup.
   	o	Choose paper size loaded in plotter, and set the 
		orientation.
   	o	Choose OK in Setup.
	o	Choose Set as default printer.
   	o	Make sure Use Print Manager is NOT selected
   	o	Close printers.
   	o	Close Control Panel.
   	o	Start Windows Application and print to the 
		CalComp TechJET Designer 54xx plotter.