WIN3.x 907/PCI Vector Driver with Classic Parallel Port:
Technical Support Hot Line1-800-CALCOMP (1-800-225-2667)  
Updated: May 1, 1996
                                                    
The Windows PCI/907 driver file (WIN31DRV.EXE) may be downloaded 
from the CalComp Website (http://www.calcomp.com) 
Self-extract the file by typing at the DOS prompt: WIN31DRV

Hardware Connection Requirements:
  PC Host Computer with a working parallel port (i.e. lpt1).
  Parallel cable, Centronics connector.
  CalComp 4036 Plotter must be connected to a PC directly for this
  configuration.  Network systems may require different communication
  parameter settings.

1. Setup Classic (4036):
   - Power ON the plotter. Install pen(s) in turret and place turret
     in the Classic.
   - Load media. Make sure both pinch rollers are down.
   - Press MENU button.
   - Press DOWN arrow key 7 times, set ORIENTATION on AUTO.
   - Press DOWN arrow key 8 times, set PLOT LIMITS on NORMAL.
   - Press DOWN arrow key, set PLOT MANAGER on YES.
   - Press DOWN arrow key, set PORT TYPE on CENTRONICS.
   - Press DOWN arrow key, set PROTOCOL on PCI.
   - Press DOWN arrow key, set SYNC # EOM CHK on C: 2, 1, 3, OFF.
   - Press DOWN arrow key 3 times, save the settings on USER # (1 to 4).
   - Press ONLINE button twice.
   - The plotter should display: ONLINE  000:00.

2. Setup Windows driver:
   - Start up Windows.
   - Double click on Control Panel.
   - Double click on Printers.
   - Highlight CCP Classic 4036 (907) on LPTx for cut-sheet media or
     CCP Classic 4036 R(907) on LPTx for roll-media.  (If the Windows
     PCI/907 driver is not installed, install it now by selecting RUN from
     the File menu bar in Program Manager and selecting the SETUP.EXE file
     from the disk directory where the Windows driver is located. Then
     follow the menu choices, selecting the appropriate Classic plotter
     driver. When done, double click on Control Panel, double click on
     Printers, and select the PCI/907 driver).
   - Choose Connect and select the LPT port that the plotter is
     connected to. (Default = LPT1).
   - Choose Setup.
   - Choose paper size loaded in plotter.
   - Choose Assign Pens.
   - Assign screen colors to pen turret position numbers.
   - Choose OK in Pen Assignments.
   - Choose OK in Setup.
   - Choose Set as default printer.
   - Make sure Use Print Manager is NOT selected.
   - Close Printers.
   - Close Control Panel.
   - Start Windows Application and print to CalComp plotter.