A.    Occasionally a problem occurs when this driver is first installed after
      which AutoCAD will crash. Usually, if the configuration default
      selections for this driver can be viewed, the default number of copies
      will be some unusually large number.  In other cases the program
      crashes before you get to that point. Perform the following:
      
      1.    At the command prompt in AutoCAD, type CONFIG.
      
      2.    Select each configuration selection (video display, digitizer,
            system console, operating parameters) and write the settings down
            on a piece of paper.
      
      3.    Quit from AutoCAD.  Change directory to the ACAD directory, by
            typing: CD \ACAD for AutoCAD 12/DOS or CD \ACADWIN for AutoCAD
            12/Windows.
      
      4.    The ACAD.CFG file, which contains the AutoCAD configuration
            settings, has become corrupted. Rename the file by typing: REN
            ACAD.CFG  ACAD.XFG.
      
      5.    Restart AutoCAD and use the settings that were written down to
            recreate a new ACAD.CFG file.
      
      6.    When configuring the plotters, first configure only the CalComp
            TechJET Personal plotter driver, bring up a test drawing,  and
            plot out a drawing  to verify that the problem is corrected
            before adding any other plotter/printer drivers that you may
            have.