WIN3.x 907/PCI Vector driver with Pacesetter Parallel Port:
Technical Support Hot Line 1-800-CALCOMP (800-225-2667)      Updated: May 1, 1996
                                                     20_WIN_P.DOC
The Windows PCI/907 driver file (WIN31DRV.EXE) may be downloaded 
from the CalComp Website (http://www.calcomp.com. 
Self-extract the file by typing at the DOS prompt: WIN31DRV

Hardware Connection Requirements:
  PC Host Computer with a working parallel port (i.e. LPT1).
  Parallel cable, Centronics connector.
  CalComp 20xx Plotter must be connected to a PC directly for this
  configuration.  Network systems may require different communication
  parameter settings.

1. Setup PaceSetter (2024, 2036):
   - Power ON the plotter.
   - Install pen(s) in turret and place turret in the Pacesetter.
   - Load media.
   - Make sure both pinch rollers are down.
   - Press MENU button.
   - Press DOWN arrow key 7 times, set ORIENTATION on AUTO.
   - Press DOWN arrow key 4 times, set PLOT LIMITS on NORMAL.
   - Press DOWN arrow key, set PLOT MANAGER on YES.
   - Press DOWN arrow key, set PORT TYPE on CENTRONICS.
   - Press DOWN arrow key, set PROTOCOL on PCI.
   - Press DOWN arrow key, set SYNC # EOM CHK on C: 2, 1, 3, OFF.
   - Press DOWN arrow key 3 times, save the settings on USER # (1 to 3).
   - Press ONLINE button twice. The plotter should display: ONLINE 000:00.

2. Setup Windows driver:
   - Start up Windows.
   - Double click on Control Panel.
   - Double click on Printers.
   - Highlight CCP PaceSetter 20xx (907) on LPTx. (If the Windows
     PCI/907 driver is not installed, install it now by selecting RUN from
     the File menu bar in Program Manager and selecting the SETUP.EXE file
     from the disk directory where the Windows driver is located. Then
     follow the menu choices, selecting the appropriate PaceSetter plotter
     driver. When done, double click on Control Panel, double click on
     Printers, and select the PCI/907 driver).
   - Choose Connect and select the LPT port that the plotter is
     connected to. (Default = LPT1).
   - Choose Setup.
   - Choose paper size loaded in plotter.
   - Choose Assign Pens.
   - Assign screen colors to pen turret position numbers.
   - Choose OK in Pen Assignments.
   - Choose OK in Setup.
   - Choose Set as default printer.
   - Make sure Use Print Manager is NOT selected.
   - Close Printers.
   - Close Control Panel.
   - Start Windows Application and print to CalComp plotter.